Springfield Pioneers of Ales with Regal Grand Esters
Forgot your password?
Forgot your username?
Create an account
Brew Day Helper
Mash/Sparge Water Calc
SPARGE Social Sites
You are here:
Mash/Sparge Water Calc
Mash/Sparge Water Calculator
Batch Size (gal)
The number of gallons you plan to put into the primary fermenter.
Grain Bill (lbs.)
Pounds of barley malt, rye, or wheat used in the recipe - excludes sugars, honey, etc. that do not absorb water readily.
Boil Time (hrs.)
Number of hours to boil the wort (e.g., a 90 minute boil would be 1.5 hrs)
Trub Loss (gal.)
The trub, cold-break, hops, chiller loss, and excess wort left when transfering from the boil kettle.
Equipment Loss (gal.)
The amount wort left at the bottom of the mash tun after emptying it.
Mash Thickness (qts/lb.)
In quarts/lb., the ratio of sparge water to grain to be used in the mash. An average value to use is 1.33 qts/lb.
Grain Temperature (deg.)
The measured temperature of the crushed grains at the time of dough-in.
Target Mash Temperature (deg.)
The temperature at which you plan to hold your mash in the mash tun.
Wort Shrinkage (pct)
The percentage which the volume of boiling wort shrinks when cooling to 68 degrees. This is a well-accepted constant value of 4%.
Grain Absorption Constant (gal/lb)
This is the number of gallons of water absorbed per pound of grain during the mash in your system. You will need to measure and adjust this value for your system parameters as they can vary greatly.
Percent Boiloff per Hour (pct/hr)
The percentage of wort boiled off into the atmosphere per hour during boil. Again, for best results, you will need to observe this value in your system and change as the strength of your burner, dimensions of your boil pot, etc. can come into play. This can be calculated noting the preBoil and postBoil volumes at the one-hour mark when boiling your next wort and plugging it into the formula :
Evaporation Pct. = 100 - (postBoil volume * 100 / preBoil volume)
Total Water Needed (gal.)
The total gallons of Mash & Sparge water needed for this brewing session.
Mash Water Needed (gal.)
Gallons of water needed for the mash based on your Mash Thickness value and Grain Bill size.
Sparge Water Needed (gal.)
Water left for sparging after the mash water has been subtracted from the total water needed.
Strike Temperature (deg.)
Temperature at which to dough-in your mash. This value assumes that your mash tun has been pre-heated.
Pre-Boil Wort Produced (gal.)
Copyright © 2008